StrumFix 3D Models

If you have a 3D printer you can print replacements parts for your StrumFix Plus using these models. Files are provided in 3MF or STL format which is compatible with most 3D printing slicer software. Contact us if you need assistance to figure out print settings etc…

If you don’t have a printer we are happy to supply replacement parts for a nominal cost.

StrumFix Adapters

Some guitars require a special adapter in order to install a Strum Fix Plus properly. You can buy them from us, or print your own using the files below.

• Jag adapter - we print these using resin in an SLA printer, but they can be printed in PLA or PETG as well. No supports needed, but it’s recommended to print these with 0.1mm layers.

• Precision Bass adapter - print in PLA or PETG. Print with supports.

• Riffmaster adapter - we print all the parts in PLA except for the spacers which are printed in resin, but all parts can be printed in PLA or PETG. Supports are required.

• Wood Strat adapter - we print these in resin on an SLA printer, but they could probably be printed using an FDM printer using supports.

• Telecaster adapter - print in PLA or PETG. Supports are required.

StrumFix Plus 2

• StrumFixPlus2 Files - contains files for the strum bar and mounting blocks.

  • strum bar - print in PLA or PETG, supports required.

  • mounting blocks -print in PLA or PETG, no supports required.

StrumFix Plus 3

The SFP3 has been discontinued, but we still support it and you can print parts using the files below.

• StrumFixPlus3 Files - contains files for the strum bar, axle, mounting blocks, and switch plungers:

  • strum bar - print in PLA or PETG, supports required.

  • axle - print using high-strength resin with an SLA printer.

  • mounting blocks -print in PLA or PETG, no supports required.

  • switch “keycaps” - printed in resin (SLA). These are small parts that require high resolution and so can’t be printed on most FDM (filament) printers.

StrumFix Plus 4

• StrumFixPlus4 Files - includes the following models:

  • strum bar - print in PLA or PETG, supports required.

  • axle - Requires high-strength resin using an SLA printer.

  • mounting blocks -print in PLA or PETG, no supports required.

  • switch “keycaps” - printed in resin (SLA). These are small parts that require high resolution and so can’t be printed on most FDM (filament) printers.

StrumFix Plus DUO

• Strum Fix DUO Files

  • strum bar - print in PLA or PETG, supports required.

  • mounting blocks -print in PLA or PETG, no supports required.